Rocom Doortello Home Guía de usuario descargar pdf (Pagina 10)

User guideDoortello HomeIssue 1.00

Page 10

To terminate the programming mode dial 3.

Please note!

If you terminate the call hanging up the handset without dialling the digit

3 all the data inserted up to this time will be lost!

Please note!

It may be that the programming mode activation using a password has been

deactivated with a previous programmation. Is this case the programming

mode is activated just after the input of the *#0 digits.

Please note!

The password could has been changed. If you hear a NOOK tone you have a

wrong password.

Please note!

As soon as the device will answer the call a maximum connection timer will

start. This is set as default at a value of 60 seconds. At the end of this time

the unit will disconnect the line. All data inserted until this time will be lost.

We suggest you to change this time if you plan an extensive

programmation.

Please note!

When you terminate the programming mode with the digit 3 all

programmed data will be transferred from the RAM to the flash memory.

This will take about 30 seconds. During this time the device is not available.

Tones during programmation

During programmation you will hear the following tones:

Answer tone: 1 short tone. Is sent when the call is answered and the unit ready

to accept more commands.

OK tone: 3 short tones. The data input or command is correct.

NOOK tone: 6 short tones. The data input or command is not correct, last data

input is lost.

Error tone: 9 short tones. There was an error on the device memory. Data could

not be stored and are lost.

Default data load

If you have to move the door phone, to change the complete programmation or

the unit was programmed wrong you can load the factory default data using

the following procedure:

*#9 OK tone #91234 OK tone

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Sin comentarios

Rocom Doortello Home Guía de usuario Pagina 10